PP MELT BLOWN FILTER CARTRIDGE - 
PP MELT BLOWN FILTER CARTRIDGE, Wholesale PP MELT BLOWN FILTER CARTRIDGE manufaturer.
PP Melt Blown Filter Cartridges Data Sheet
PP Melt Blown Filter Cartridge is fusing and intertwined of polypropylene resin without any chemical glues. The cartridges are glued at random to form 3D micro pore which will make the cartridge 3 layers with fine fibers in surface and coarse fibers and deep filtration.
As the fiber and density form high filtration rating and pollutants holding capacity on diameter of filter cartridge, low pressure drop, gradual changing deep filtration structure with loose outside and close inner, strong pollutants holding capacity, it can remove contaminant effectively, such as suspended substance, particulate and rust, providing efficient filtration and long service life.
Applications
Drinking Water Treatment
●Electronic
●Industrial Water Treatment
●Plating
●Chemicals, solvents
Features
●Three layers structure cartridge offers high dirt holding capacity,longerservice life
●Formed by thermal bond without using any binders and adhesives.
●100% Pure Polypropylene will not cause any pollution to water
●Wide Chemical compatibility
●Groove design to extend the filtration surface area.
●All kinds of adaptors are available.
●FDA compliance material
SpecificationsDimensions:
●Outside Diameter: 63mm, 115mm or up to customers’ request
●Inside Diameter: 28mm,30mm
●Length: 9.75”,9.87”,10〞, 20〞, 30〞, 40〞, 50〞, 60〞
Material of Construction:
●Filter media: PP
●End caps: PP
●Cores: PP
●Gaskets/O-ring: Silicone, EPDM, NBR, Viton
Performance
●Removal Rating: 1,3,5,10,25, 50,100,150 μm
●Maximum Differential Pressure: 2.0 bar @ 21℃
●Maximum Operating Temperature: 82℃
Flow Rate vs. Differential Pressure
Differential Pressure (bar)
Flow Rate (GPM),water，20℃
Order Information
Normal Product Code: COXPP-Rating-Length
| COXPP | Rating | Length | End cap type | Seal material |
| PP | 0100:1μm | 10: 10″ | III-222/Flat end | V:Viton |
| Melt Blown | 0300:3μm | 20: 20″ | IV-222/Fin | S: Silicone |
| 0500:5μm | 30: 30″ | V-226/Flat end | E:EPDM | |
| 1000:10μm | 40: 40“ | VI-226/Fin | B:NBR | |
| 2000:20μm | 50:50“ | |||
| 3000:30μm | 60:60” | |||
| 5000:50μm | ||||
| 7500:75μm | ||||
| 10000:100μm |
For Example:
COXPP-0100-10-III-S
PP，Rating: 1um，Length:10″，226/Flat End,Seal Material: Silicone
PP MELT BLOWN FILTER CARTRIDGE
Fág freagra